How to use flood control and drainage gasoline and clean water pumps

1. Safety regulations for gasoline engine water pumps:
2. Before using the gasoline engine water pump, be sure to add the specified engine oil.

2. It is strictly prohibited to add gasoline when the engine is running.

3. It is prohibited to place flammable materials near the muffler exhaust port.

4. The gasoline engine water pump should be placed in a flat place for use.

5. Be sure to add enough water to the pump body before use. The remaining water in the water pump is hot and may cause burns, so please be careful.

6. Before operating the gasoline engine water pump, a filter must be installed at the end of the water pump to prevent foreign matter from entering and clogging or damaging the internal components of the water pump.

7. The gasoline engine clean water pump is prohibited from pumping muddy water, waste engine oil, alcohol and other substances.

8. When pumping water from the well chamber of the biogas pipeline, pay attention to detecting poisonous gas to prevent the risk of explosion.

2. Preparation for starting the gasoline engine water pump:

1. Check the gasoline engine oil before starting:

1. The engine oil must be added to the specified oil level. If the engine is operated without enough lubricating oil, it will cause serious damage to the gasoline engine. When inspecting the gasoline engine, make sure it is stopped and on a level surface.

2. Air filter inspection:

Never run a gasoline engine without an air filter, otherwise the wear of the gasoline engine will be accelerated. Check the filter element for dust and debris.

3. Add fuel:

Use automobile gasoline, preferably unleaded or low-lead gasoline, which can reduce deposits in the combustion chamber. Never use engine oil/gasoline mixture or dirty gasoline to avoid dust, garbage and water falling into the fuel tank.

warn! Gasoline is very flammable and will burn and explode under certain conditions. Refuel in a well-ventilated area.

2. Start the engine

3. Turn off the engine

1. Close the throttle.

2. Close the fuel valve.

3. Turn the engine switch to the "OFF" position.