2 Stroke Gasoline Engine Power String Trimmer Petrol Brush Cutter

1、 Material preparation

Weeding machine, rope, screwdriver, wrench.

2、 Dismantling the core wheel

1. Use a wrench to remove the outer cover of the core wheel.

2. Use a screwdriver to remove the original rope.

3. Remove the core wheel and find the two holes for the rope on the core wheel.

3、 Rope installation

1. Twist the new rope into a small ring, pass it through the hole in the center of the core wheel, put the rope end into the small hole, and tighten the screw with a wrench.

2. Wrap the rope around the groove of the core wheel once, then pass it through another hole and tie the rope head tightly to the core wheel.

3. Reinstall the core wheel onto the brush cutter and screw on the outer cover.

4、 Testing

1. Pull the rope to see if it can start normally.

2. After starting the brush cutter, observe whether the rope can automatically retract.

matters needing attention:

When installing the rope, it is important to pay attention to the length and tightness of the rope. If it is too tight, it can easily cause brake failure, while if it is too loose, it will be difficult to start.

When disassembling the core wheel, pay attention to the spring next to the core wheel and do not let the spring fall.

3. When using a screwdriver to disassemble an old rope, it is important to be careful to prevent the rope from suddenly popping out to prevent danger.

Summary:

The correct installation of the brush cutter rope has a significant impact on the service life and efficiency of the equipment. Therefore, it is necessary to carefully follow the steps during installation and pay attention to safety precautions. If you are not clear about the installation steps, it is recommended that you seek professional assistance.