cordless lithium electric chain Saw

Lithium chainsaw turn not move what problem

The failure of the lithium saw to turn may be due to the following reasons:

The battery is low. Low battery power is one of the most common reasons why lithium saws don't turn. In this case, you need to charge the battery or replace it with a new battery.

The battery is in poor contact. If the battery contact is poor, it will also cause the chainsaw to not work properly. Check that the battery is properly installed and in good contact.

Safety device triggered. The safety device of the lithium saw may be triggered, and it is necessary to check whether the brake is on or off the lock state.

The motor is overheating. If the motor overheats due to prolonged use, it may not work. At this time, you should wait for the motor to cool down before trying to use.

The motor or circuit board is faulty. Motor failure or circuit board burning is also one of the reasons why the chainsaw can not turn. In this case, professional inspection and repair may be required.

The controller is faulty. If the controller of the saw fails, it will also cause the motor to fail to work. You may need to replace the controller.

The switch is damaged. The switch is a key component to start the motor, and if the switch is damaged, the saw will not work properly. You can try to replace the switch to solve the problem.

Other faults. If the drive gear is damaged or worn, it may require specialized knowledge and skill to repair it.

If the lithium saw can not turn, it is recommended to check the battery power and contact conditions. If the problem persists, you should promptly contact after-sales service or professionals for inspection and repair.